Cleaning And Care; Dry Cleaning - Carrera 9113110 Bedienungsanleitung

Trimming Long Hair
Use the hair trimmer on the rear of the shaver to shorten beard and sideburns.
1. Take off the protective cap.
2. Push the hair trimmer upward.
;
3. Use the on / off switch (4) to switch on the shaver.
4. After use, switch off the shaver, push the hair trimmer into its basic
position and clean the shaver (→ 06. Cleaning and Care).
Three-day stubble shave
1. You can use the 3­day stubble attachment (7) to trim your beard to a hair
length of 3 mm.
2. Place the beard attachment onto the shaving head so that it is firmly
attached to it.
3. Trim your beard as you would normally do when shaving.
NOTES:
Observe that the 3­day stubble attachment is intended only to limit the
beard hair growth to a length of 3 mm, and that it is not designed to trim
longer hair to 3 mm.
When using the 3­day stubble attachment, the direct contact of the shaving
foil to the skin is lost. Consequently, the shaving system is no longer naturally
"greased" by sebum.
4. To ensure constant shaving performance, apply a drop of blade or sewing
machine oil after wet cleaning. See section "Cleaning with Water".

28

06. Cleaning and Care

DANGER!
• Remove the wall power supply from the power point before
cleaning the shaver.
• Never submerge the entire shaver in water.

Dry Cleaning

WARNING!
• Always switch off the shaver before cleaning it.
CAUTION! Risk of material damage
• Do not use any harsh or abrasive cleaning agents.
• Do not remove the shaving foil from the shaving foil frame
and do not clean it with the brush.
• The cutting blades must not be removed for cleaning purposes.
The springs located underneath the cutting blades might jump out and
get lost. Remove the cutting blades for replacement purposes only (see
"Replacing Parts", page 31).
NOTE: Clean the shaver after every use to warranty optimal results.
1. Press in the two lateral unlocking buttons (3) at the same time and
remove the shaving head (2) off the appliance.
2. Knock the blade head on a flat surface and blow it out.
3. Clean the cutting blades with the cleaning brush.
NOTE!
Cutting foil can be removed carefully from
the blade head for cleaning (see Fig.
➌
).
➌

29