GYS PACK 660 Bedienungsanleitung Seite 10

Translation of the original instructions
• Avoid flames and sparks. Do not smoke.
• Protect the electrical contacts of the battery against short-
Acid projection hazard!
• Wear safety goggles and protective gloves
• If your eyes or skin come into contact with battery acid, rinse
Connection / disconnection
• Disconnect the power supply before connecting/
• The terminal of the battery that is not connected to the car
• After the charging process, disconnect the battery charger
Connection:
• Class II device (charger booster)
• Class III device (booster)
• This machine is fuse-protected
• Connection to the mains must be made according to the
Maintenance:
• If the charging / power supply cable is damaged, the pro-
• The power supply cable cannot be replaced. If the cable is
• Service should be performed by a qualified person
• Warning! Always remove the power plug from the wall socket
• Regularly take off the cover and remove dust with an air gun.
• Under no circumstances should solvents or other aggressive
• Clean the device's surfaces with a soft, dry cloth.
10
GYSPACK 660 / 750
circuiting.
the affected part of the body with plenty of water and seek
immediate medical assistance.
disconnecting the device to/from the battery
frame must be connected first. The other connection must be
made on the car frame, far from the battery and the fuel line.
The battery charger must be connected to the power supply
network.
from the power supply network and remove the connector
from the car frame and then the connector from the battery, in
this order.
national installation regulations.
duct must be disposed.
damaged,the device should not be used.
before carrying out any work on the device.
Take the opportunity to have a qualified person check the
electrical connections with an insulated tool.
cleaning agents be used.
EN