Using The Inverter - Dometic SINEPOWER DSP1312T Montage- Und Bedienungsanleitung

SinePower
9.6 Connecting the fault display relay
You can install a relay which monitors whether the 230 V input is connected.
Thereby you can, for example, implement an immobiliser so that the vehicle cannot
be started when the 230 V input is connected.
➤ Connect the relay as shown (fig. a):
– NO: normally open contact
– COM: common contact
– NC: normally closed contact
Relay specification:
Maximum voltage
250 Vw
12 V/24 Vg
10

Using the inverter

10.1 Switching on the inverter
➤ Set the main switch (fig. 2 1) of the inverter as follows:
– "0": to switch the inverter permanently off
– "I": to switch the inverter permanently on
– "II": to switch the inverter on and off with a remote control (accessory)
➤ The inverter performs a self-test when starting.
✓ After the self-test is completed successfully, the LED lights up blue (fig. 2 2).
EN
Load
Ohmic
Ohmic
Using the inverter
Current consumption
NO NC
0.5 A 0.5 A
1 A 1 A
17