4
Getting started
4.1 Installation tips
First switch off all devices (TV and HDMI sources) before connecting them to the
MegaView 141 UHD™. If a device cannot be turned off, please remove its plug
from the wall socket.
For the best picture and sound quality, only use High Speed HDMI® certified
cables.
Please be careful when connecting your HDMI cables. These damage easily.
4.2
Requirements Cat6 cable
UTP, FTP or STP cable
24AWG or lower
Solid twisted pair
100 ohm at 1MHz
RJ-45 connection according to EIA/TIA T568B standard
To optimise transmission quality, use solid twisted pair CAT6 cables.
4.3
Installing the transmitter and receiver
In order to check proper functioning of the system, it is advisable to test the set-up first
using a short CAT6 cable.
1.
Switch off all devices prior to installation.
2.
Connect the HDMI source (Blu-ray disc player, TV decoder, media center PC,
etc.) to the MegaView 141 UHD™ transmitter [1] using an HDMI cable (not
included).
3.
Connect the MegaView 141 UHD™ receiver [2] to your TV or projector using an
HDMI cable (not included).
4.
Use one CAT6 networking cable to connect the transmitter and receiver of the
MegaView 141 UHD™ [3].
Please note! The MegaView 141 UHD™ will only work when using a direct connection
between the transmitter and the receiver and cannot be connected to an existing home
network (LAN), since this may cause damage to the device or your network router.
5.
Connect the power adapter [4] to the "12 VDC" connector of the MegaView 141
UHD™ transmitter or receiver and plug the adapter into a wall socket.
Please note! Do not place the MegaView 141 UHD™ transmitter or receiver in an
enclosed space such as a TV cabinet or equivalent. Provide adequate ventilation to
ensure that the product is functioning properly and to protect against overheating.
8
© MARMITEK