Makita BTW201 Betriebsanleitung Seite 7

Auto-stop setting for number of impacts (Fig. 7)
This tool has a convenient auto-stop mechanism that allows you to preset the desired number of impacts in terms of
the application. The tool then stops automatically after reaching the preset number of impacts.
1. To set the dial on the back of the tool, first slide out the battery cartridge by sliding the button on the side of the
cartridge.
2. Two dials can be seen on the battery holder side. Use a slotted screwdriver to set the dial to a desired 2-digit set-
ting.
3. You cannot set the auto-stop setting for fastening with more than 200 impacts (over 4 sec.)
Note:
Do not force the dial when turning. You might break it.
Dial setting and function (Fig. 7)
Bolt fastening
Dial setting
01 – 98
99
00
Temporary bolt fastening and loosening
By using the B or C on the left dial in combination with one of the digits (from 0 to 9) on the right-hand dial, you can do
temporary bolt fastening or bolt loosening.
Dial setting
B [*]
Select dial 0 – 9 for B [*]
C [*]
Select dial 0 – 9 for C [*]
Clockwise
Tool stops after the twice
the set number of impacts
is reached. See the next
section for the appropriate
fastening torque.
Pull the trigger to start the tool; release it to stop.
No rotation even with trig-
ger pulled.
Clockwise
After catching the first
impact, tool stops [*] x 0.1
seconds later.
Pull the trigger to start the
tool; release it to stop.
Counterclockwise
Pull the trigger to start the
tool; release it to stop.
Pull the trigger to start the
tool; release it to stop.
Counterclockwise
Pull the trigger to start the
tool; release it to stop.
After stopping to impact,
tool stops [*] x 0.1 seconds
later.
Application
Bolt fastening while con-
trolling the number of
impacts.
Bolt fastening without con-
trolling the number of
impacts; or when fasten-
ing with more than 200
impacts (over 4 sec.)
—
Application
For temporary bolt fastening.
To loosen bolts.
7