Auto Power Off; Replacing The Battery - Silvercrest 271626 Bedienungsanleitung


The user profile memory (22), as well as the entered height flash in sequence a few times
before the measurement of the other values starts. Remain standing on both electrodes (6)
until the measurement is complete. Remain as still as possible during the weighing process as
the measurement result may be distorted otherwise.

Once the measurement is successful, the following values are displayed four times in
succession:
o Body weight
o Body fat percentage (15) and obese (18), overweight (19), normal weight (20) or
underweight (21)
o Water percentage (16)
o Muscle percentage (25)
o Bone percentage (9)
o Recommended calorie intake per day (17)

Auto Power Off

The diagnostic scales have an automatic switch-off function (Auto Power Off function). After
displaying the measurement result, the diagnostic scales switch off automatically.

Replacing the battery

Replace the battery when it is empty. Replace the
battery when it is empty. To insert the lithium
battery CR2032, open the cover of the battery
compartment (7) at the rear of the bathroom
scales by slipping your finger into the slot on the
side of the battery compartment (7). Now remove
the cover of the battery compartment (7).
To remove the battery, push it down a bit (see the
direction of the arrow in the illustration). You can
then remove the battery from the holder.
Then insert a new lithium battery CR2032. Pay
attention to the polarity when inserting the battery.
This is indicated in the battery compartment (7),
and the + symbol on the lithium battery CR2032
must be visible, as shown in the adjoining
illustration.
Then replace the
compartment (7). The diagnostic scales are now
ready to use.
cover on the battery
SilverCrest SPWD 180 E1
English - 11