Adjusting The Material Volume (Fig. 6); Setting The Amount Of Air (Fig. 7); Spray Technique - WAGNER TexPerfect FLEXiO 525 Bedienungsanleitung

TexPerfect Flexio 525

13. Adjusting the Material Volume (Fig. 6)

Set the material volume by turning the regulator on the trigger guard of the spray gun.
lower material volume
higher material volume

14. Setting the Amount of Air (Fig. 7)

Depending on the viscosity of the material to be sprayed and the finish of the
i
object to be coated, it may be advisable to vary the amount of air. Very low viscosity
materials do not have to be atomised with the maximum amount of air. In this case it
is advisable to reduce the amount of air and thus minimize the spray vapour.
This also applies for the use of the low-scale and radiator/detail spray attachment
(accessory).
Turn the air quantity regulator (fig. 7, 1) until the level you want is above the arrow.
thin paint
thick paint (e.g. interior wall paint) 

15. Spray Technique

General
The spray result depends heavily on the smoothness and cleanliness of the
i
surface to be sprayed. Therefore the surface should be carefully prepared and
kept free of dust.
•
Cover all surfaces not to be sprayed.
Important: Start at the edge of the area to be sprayed. Start the spray
i
movement first of all, and then press the trigger. Avoid interruptions
within the area to be sprayed.
•
The spray movement should come from the arm, not just from the wrist. This ensures
that a uniform distance is maintained between the spray gun and the spray surface
during the spray operation.
Fig. 8 A: CORRECT Even distance to the object.
Fig. 8 B: INCORRECT An uneven distance will result in uneven paint application.
•
Move the spray gun evenly cross-wise or up-and-down, depending on the spray
pattern setting.
•
An even movement of the spray gun results in an even surface quality.
turn anti-clockwise (-)

turn clockwise (+)

Level min to 6

Level 6 to max
GB
9