Spark Plug; Air Intake - Stiga PARK COMPACT 16 Gebrauchsanweisung

Silent:
1. Dismantle the air filter cover (9:R) by undoing
its screw.
2. Dismantle the filters. The pre-filter (9:B) is
placed over the air filter (9:A). Make sure that
no dirt gets into the carburettor. Clean the air fil-
ter housing.
3. Wash the pre-filter in liquid detergent and wa-
ter. Squeeze dry. Pour a little oil on the filter and
squeeze in the oil.
4. Clean the paper filter by tapping it gently
against a flat surface. If the filter is very dirty,
replace it.
5. Assemble in the reverse order.
Compressed air or petroleum-based solvents such
as kerosene may not be used for cleaning the paper
filter insert. This will damage the filter.
Do not use compressed air for cleaning the paper
filter insert. The paper filter insert must not be
oiled.

5.10 SPARK PLUG

The spark plug(s) must be replaced every 200
hours of operation (=at every other basic service).
Before disconnecting the spark plug, clean around
its mounting.
Spark plug: Champion RC12YC or equivalent.
Electrode distance: 0.75 mm.

5.11 AIR INTAKE

See 8:T. The engine is air-cooled. A blocked cool-
ing system can damage the engine. Clean the en-
gine's air intake after 50 hours of operation. More
meticulous cleaning of the cooling system is car-
ried out during each basic service.
All manuals and user guides at all-guides.com
ENGLISH
5.12 LUBRICATION
All lubrication points in accordance with the table
below must be lubricated every 50 hours of opera-
tion as well as after every wash.
Object
Centre point 4 grease nipples.
Steering
chains
Tensioning
arms
Control
cables
5.13 FUSE
In the event of electrical faults, check/replace the
fuse, 20 A. See 8:S.
6 PATENT - DESIGN REGISTRA-
This machine or parts thereof is covered by the fol-
lowing patent and design registration:
SE9901091-0, SE9901730-3, SE9401745-6,
US595 7497, FR772384, DE69520215.4,
GB772384, SE0301072-5, SE04/000239 (PCT),
SE0401554-1, SE0501599-5.
GGP reserves the right to make alterations to the
product without prior notification.
Translation of the original instructions
Action
Use a grease gun filled with
universal grease. Pump until
the grease emerges.
Brush the chains clean with a
wire brush.
Lubricate with universal
chain spray.
Lubricate the bearing points
with an oil can when each
control is activated.
Ideally carried out by two
people.
Lubricate the cable ends with
an oil can when each control
is activated.
Must be carried out by two
people.
TION
EN
Fig-
ure
17
-
18
18
57