Transport; Use; Switch On And Operate The Led Lighting; Switch Off The Led Lighting - Juskys Murcia 28981 Gebrauchs- Und Montageanleitung

NOTICE
Material damage.
►Before connecting the device, check whet-
her the mains voltage and mains frequen-
cy of the device are identical to those of the
mains supply.
►Connect the power supply unit to an easi-
ly accessible power outlet only after the pro-
duct has been fully assembled and after the
final choice of location has been made.
Note: The receiver [O] of the control unit should
be positioned next to or above the bed so that
the infrared signal of the remote control is not blo-
cked.

5. Transport

CAUTION
Risk of injury and material damage due to in-
correct transport.
►Disconnect the power supply unit from the
power outlet before transport.
►Only transport the product when it is disas-
sembled and with at least one other per-
son.
►Do not push the product over the ground.

6. Use

CAUTION
Risk of injury due to improper use.
►Use the product in accordance with its in-
tended use, see chapter "1.2 Use as in-
tended" on page 12.
NOTICE
Damage to the product due to incorrect
use.
►Make sure that the product is free from
damage before use. Use of a defective
or damaged product is prohibited.

6.1 Switch on and operate the LED lighting

1. Press the "ON" key [5] on the remote con-
trol.
► The LED lighting starts to light up.
2. Use the control panel [1] to set the desired
color by pressing the key of the respective
color.
3. Set the desired brightness with the keys [2]
and [3].
4. Set the desiredlighting mode with the keys
[6] - [9].

6.2 Switch off the LED lighting

►Press the "OFF" key [4] on the remote control.
►Unplug the power supply unit from the power
outlet if it will not be used for a long time.

7. Store

NOTICE
Damage to the product due to incorrect
storage.
►Unplug the power supply unit from the
power outlet if it will not be used for a
long time.
►Protect the product from dust and mo-
isture.
►Store the product assembled and upright
or disassembled afterwards in a dark,
cool, dry and well-ventilated place.
►Do not place any objects on the pro-
duct because of deformations that
may occur.

8. Cleaning and maintenance

8.1 Cleaning the bed

WARNING
Danger to life due to electric shock.
Damaged cables can cause short circuit, fire
and electric shock.
► Disconnect the power supply unit from the power
outlet before cleaning and before transport.
► Do not clean the electronics with damp cleaning
agents.
NOTICE
Damage caused by incorrect cleaning
agents.
►Check the compatibility of the clea-
ning agent with the surface on an in-
conspicuous area.
►Use only cleaning cloths and soft brushes.
►Remove dust and light dirt with a damp cloth or a
soft brush.
►Use a mild, non-flammable and food-safe clea-
ning agent or a cloth dampened with water for
heavy soiling.Regular maintenance increases
the safety and longevity of your product.
EN
15