Place Of Installation; Transport - Juskys Milano 5 23718 Gebrauchs- Und Montageanleitung

4. Mounting
ATTENTION
Damage to the product due to incorrect
assembly.
►Assemble the product completely and
safely.
►Assemble the product with at least one
second person.
►Screw the screws hand-tight into the
connecting holes and only tighten the
screws in the last step to prevent the
parts from jamming.

4.1 Place of installation

1. Select a suitable installation location that
meets the following requirements:
• The installation location is dry and can be venti-
lated regularly.
• The installation site is not permanently exposed
to the sun and strong temperature fluctuations.
• The subsurface of the installation site is level and
non-slip.
2. Follow the assembly steps shown, observing
the safety instructions, see „14. Assembly" on
page 33.

5. Transport

CAUTION
Risk of injury and material damage due to in-
correct transport.
►Only transport the product when it is dis-
mantled.
►Only carry out minor site corrections with
the assistance of a second person and
with protective equipment.
12
6. Use
CAUTION
Risk of injury due to improper use.
►Use the product in accordance with its in-
tended use, see chapter „1.2 Use as inten-
ded" on page 10.
CAUTION
Risk of injury from being trapped and tip-
ping over.
►Only use the chairs on a level and sta-
ble surface.
►Only use the chairs when they are fully
unfolded.
►Adjust the table using the adjustable feet so
that it stands level and without wobbling on
the surface.
►Raise both armrests evenly to set the desired
backrest angle.
►Let both armrests lock securely in the desired
position by lowering them.
►Adjust the backrest angle only when sitting
and only in such a way that you relieve the
backrest from the upper body.
7. Disassembly
►Disassemble the product in reverse order of as-
sembly, see chapter „14. Assembly" on page
33.
8. Store
ATTENTION
Damage to the product due to incorrect
storage.
►Store the product assembled and upright
or disassembled afterwards in a dark,
cool, dry and well-ventilated place.
►Protect the product from dust and mo-
isture.
►Do not place any objects on the pro-
duct because of deformations that
may occur.