Cleaning And Maintenance - EUFY T2120 Benutzerhandbuch

English

Cleaning and Maintenance

For optimal performance, follow the instructions below to clean and maintain RoboVac
regularly. The cleaning/replacement frequency will depend on your usage habits of
RoboVac.
Recommended cleaning/replacement frequency
RoboVac Part Cleaning Frequency
Dust Collector After each use
Filters Once every week
Rolling Brush Once every week
Side Brushes Once every month
Brush Guard Once every month
Sensors Once every month
Charging Pins Once every month
Swivel Wheel Once every month
Clean the Dust Collector and Filters
Press the dust collector release button to pull the dust collector out.
Open and empty the dust collector.
1
Remove the pre-filter by pulling the hooks as shown.
20
Replacement Frequency
-
Every 2 months
Every 6-12 months
Every 3-6 months (or when visibly worn)
Every 3-6 months (or when the silicone
rubber strip on the brush guard becomes
visibly worn)
-
-
-
2
Take out the foam filter and high-performance filter.
Clean the dust collector and filters with a vacuum cleaner or a cleaning brush.
Put the filters and pre-filter back together in the dust collector.
Push the dust collector back into the main unit.
You can wash the dust collector, pre-filter and foam filter with water. Be sure to
air-dry them thoroughly before reassembling. Do not wash the high-performance
filter with water, as it may damage the filter and reduce the suction power.
Clean the Rolling Brush
Pull on the release tabs to unlock the brush guard as shown.
Lift the rolling brush to remove.
Clean the rolling brush with the provided cleaning tool or a vacuum cleaner.
Reinstall the rolling brush by inserting the fixed protruding end first and then clicking
into place.
English
21