eta GUSTUS MAGNUS Bedienungsanleitung Seite 52

GB
Therefore first fill in the container with warm water (max. 50 °C) with a small amount of
detergent. Then put the container on the food processor, set the maximum rotational speed
and run for 1 minute. Then rinse the container with clear water.
– Do not let the blender running without any food!
– Never remove the container lid F1 when the motor unit is running!
– Never pour boiling liquids in the container.
– Before removing the blender lid or container, wait until the rotating parts completely stop.
– When the blender is in the state of idle operation, e.g. the blade fails to touch the foods,
unplug the unit until the foods have been relaxed.
Use
Remove the lid, put or pour the food into the container and replace the lid. We recommend
that you always switch on the blender to minimum revolutions and then gradually increase the
performance as required.
The recommended processing speed is 1 to M
– Never fill the container with liquids producing foam (for example milk) up to „MAX" level
to prevent overspill. We recommend 1 litre at maximum.
III.6) Attachment for ice-cream (R)
Description (Fig. 12)
R0 – maker body
R1 – Spiral feeder
R2 – Sealing
– Do not put the attachment or its components into a freezer or a refrigerator prior to use.
Assembly
Assemble the ice cream maker R and connect it to the head of the drive unit according to
pic 7. Warning: Check whether the sealing R2 is put properly on its place in the cover with
outlet R3. Apply reverse procedure to disassemble the unit and remove it from the motor
unit head.
Use
Put the food in the hopper one by one to prevent overfilling the ice-cream maker chute to the
top. The pusher R4 is intended for continuous pushing the food to the auger's reach. Use
the pusher after each piece of food is inserted in the feed chute, not for pushing just after
the chute is completely full to the top edge. If you look inside the feed chute opening after
removing the pusher, you can visually check the auger condition and clearness.
We recommend processing at MAX speed. Processing speed 200 g / min.
Safety hints and tips
Tips
R3 – Cover with outlet
R4 – Pusher
R5 – Hopper
Safety hints and tips
52 / 111