Fakir prestige AS 1111 Bedienungsanleitung Seite 29

Fig. 1
Fig. 2
Fig. 3
Fig. 4
Assembly/storage
1. Separate the back part of the charging sta-
tion from the front part by pushing it down-
ward. (Fig. 1)
2. Find a suitable location on an indoor wall,
near an electrical outlet. Bear in mind the
warnings described above.
3. Hold the back part on the wall as shown in
Fig. 2, mark the position of the mounting
screws and then drill the holes for the
screws.
WARNING!
Before drilling the holes, make sure that no
electrical wires or pipes will be damaged.
4. Use the included anchors and screws to
mount the charging station. Insert the an-
chors in the holes and then screw the
screws into the anchors to a clearance of
about 3 mm to the wall. Now hang the back
part on the screws and tighten the screws.
Then connect the front part with the back
part.
5. Plug the small plug of the charger into the
left jack on the charging station. (Fig. 3)
If you wish to charge the battery with the au-
tomobile charging cable using the socket of
a car, caravan or boat, make sure that the
voltage is set to 12V. Then plug the small
plug of the vehicle charging cable into the
right jack on the charging station. (Fig. 4)
9