Mains Connection; Operation; Menu Structure - EuroLite LED SLS-30 COB UV Floor Bedienungsanleitung

MAINS CONNECTION

The device uses an auto-range power supply that accepts input voltages between 100 und 240 volts.
1 Connect the device via the mains cable to a grounded mains socket. Thus the unit is switched on.
2 To switch off the unit, disconnect the power plug.
3 Do not connect the unit to the mains voltage via a dimmer. For a more convenient operation, use a mains
outlet which is switchable.
4 The jack POWER OUT allows for power supply of further devices. To interconnect several devices,
connect the jack POWER OUT to the input POWER IN of the next unit until all units are connected.
Matching power cables with P-Con plugs are available as accessories. In this manner, up to 8 devices
can be linked.

OPERATION

After connecting the device to the mains it is ready for operation. The display indicates the last operating
mode. The operating modes can be selected by means of the display and the control buttons. All settings
remain stored even if the device is disconnected from the mains. The device can be operated in stand-alone
mode via the control board or in DMX-controlled mode via any commercial DMX controller.

Menu structure

Press the MENU button so many times until the desired function is indicated on the display. Use the ENTER
button to select the function. With the buttons UP and DOWN you can select the mode. Confirm with
ENTER.
Mode
DMX mode
Automatic mode
Sound control
Running speed in
automatic mode and
sound control
Microphone sensitivity
for sound control
Static color mode
Dimmer
Sound control silent
scene
Display
4CH
Addr 2CH
1CH
Auto Au 1 – 4
Soun So 1 – 3
SPEE SP 1-9
SEnS SE 1-9
Colo u000-255
diMM dI 1-dI 9
on
SILE
oFF
21/28
4-channel mode and start address
d001-512
d001-512 2-channel mode and start address
d001-512 1-channel mode and start address
Program 1 – 4
Program 1 – 3
Program running speed
slow > fast
Microphone sensitivity
low > high
UV 0-100%
Total brightness (Auto, Soun, and
Colo modes)
dark > bright
LEDs off if there is no music signal
LEDs remain on if there is no music signal
Function
00126035, Version 1.0