Replacing The Power Cable; Cleaning, Maintenance And Ordering Of Spare Parts; Disposal And Recycling - EINHELL BT-SM 2534 Dual Originalbetriebsanleitung

Anleitung_BT_SM_2534_Dual_SPK7:_
GB
7.8 Transport (Fig. 1-3)
Retighten the locking screw (14) to secure the
turntable (17) in place.
Activate the release lever (3), press the machine
head (4) downwards and secure with the safety
pin (25). The saw is now locked in its bottom
position.
Fix the saw's drag function with the locking screw
for drag guide (24) in rear position.
Carry the equipment by the fixed saw table (18).
To set up the equipment again, proceed as
described in section 6.2.
7.9 Operating the laser (Fig. 2)
To switch on: Move the ON/OFF switch (36) to the
"I" position to switch on the laser (35). A laser line is
projected onto the material you wish to process,
providing an exact guide for the cut.
To switch off: Move the ON/OFF switch (36) to the
"0" position.
7.10 Electric brake
For safety reasons, the equipment is supplied with an
electric brake system for the saw blade. The
equipment may therefore emit an odor or generate
sparks when it is switched off. This has no influence
on the operational performance or safety of the
equipment.

8. Replacing the power cable

If the power cable for this equipment is damaged, it
must be replaced by the manufacturer or its after-
sales service or similarly trained personnel to avoid
danger.
9. Cleaning, maintenance and ordering
of spare parts
Always pull out the power plug before starting any
cleaning work.
9.1 Cleaning
Keep all safety devices, air vents and the motor
housing free of dirt and dust as far as possible.
Wipe the equipment with a clean cloth or blow it
down with compressed air at low pressure.
We recommend that you clean the equipment
immediately after you use it.
Clean the equipment regularly with a damp cloth
and some soft soap. Do not use cleaning agents
or solvents; these may be aggressive to the
plastic parts in the equipment. Ensure that no
water can get into the interior of the equipment.
22
24.01.2011 8:47 Uhr Seite 22
9.2 Carbon brushes
In case of excessive sparking, have the carbon
brushes checked only by a qualified electrician.
Important. The carbon brushes should not be
replaced by anyone but a qualified electrician.
9.3 Servicing
There are no parts inside the equipment which
require additional maintenance.
9.4 Ordering replacement parts:
Please provide the following information on all orders
for spare parts:
Model/type of the equipment
Article number of the equipment
ID number of the equipment
Spare part number of the required spare part
For our latest prices and information please go to
www.isc-gmbh.info
10. Storage
Store the equipment and accessories out of children's
reach in a dark and dry place at above freezing
temperature. The ideal storage temperature is
between 5 and 30 °C. Store the electric tool in its
original packaging.

11. Disposal and recycling

The equipment is supplied in packaging to prevent it
from being damaged in transit. The raw materials in
this packaging can be reused or recycled.
The equipment and its accessories are made of
various types of material, such as metal and plastic.
Defective components must be disposed of as
special waste. Ask your dealer or your local council.