Husqvarna K 1270 SmartGuard Bedienungsanweisung Seite 28

Function inspection
Replace
Safety devices on the product on page 8 .
* Refer to
Cutting blades on page 11 .
** Refer to
To clean externally
• Flush the product externally with clean water after
each day of operation. If it is necessary, use a brush.
To clean the cold air intake
Note:
A dirty or blocked air intake makes the product
too hot. This can cause damage to the piston and
cylinder.
• Clean the cold air intake if it is necessary.
• Remove blockage, dirt and dust with a brush.
To examine the spark plug
Note:
Always use the recommended spark plug type.
Use of the incorrect spark plug can cause damage to the
piston and cylinder. For recommended spark plug refer
Technical data on page 39 .
to
28
Daily
General inspection
Fuel leaks
Water delivery system
Throttle lockout*
Stop switch*
Blade guard and SmartGuard*
Cutting blade**
Weekly
Vibration damping system*
Muffler*
Drive belt
Carburetor
Starter housing
Examine the spark plug if the product is low on power,
does not start easily or if it operates unsatisfactorily at
idle speed.
1. Loosen the 3 screws on the air filter cover and
remove the air filter cover.
Monthly Yearly
Fuel system
Air filter
Clutch
Fuel filter
1631 - 001 - 04.05.2021