Husqvarna K 1270 SmartGuard Bedienungsanweisung Seite 25

WARNING:
rope around your hand.
7. Pull the starter rope slowly until you feel a resistance
as the starter pawls engage. Then pull continuously
and quickly.
CAUTION:
rope fully and do not let go of the starter
rope handle when the starter rope is
extended. This can cause damage to the
product.
8. Push the throttle trigger to disengage the start
throttle and set the product at idle speed.
To stop the product
WARNING:
continues to rotate for a while after the
engine stops. Make sure that the cutting
blade can rotate freely until it fully stops. If it
is necessary to stop the cutting blade
quickly, let the cutting blade lightly touch a
hard surface. Risk of serious injury.
1631 - 001 - 04.05.2021
Do not wind the starter
Do not pull the starter
The cutting blade
• Move the STOP switch to the right to stop the
engine.
Rail cutting (K 1270 II Rail)
General
CAUTION:
on the product during transport or when you
move the product. When the product and the
rail fixture are put together, there is a larger
risk of damage than when they are
disconnected. Damages, such as bent parts,
can result in less accurate cuts.
To install the rail fixture
CAUTION:
rail before you install the product to the rail
fixture. There is a risk that the rail fixture is
not installed at a correct angle if the product
is installed first.
Do not install the rail fixture
Install the rail fixture to the
25