Maintenance And Cleaning; Cleaning; Replacing The Grinding Disc - Parkside PSG 85 A1 Originalbetriebsanleitung

Secure the adjusting screw
justing nut .
14b
Secure the links in the chain guide
turning the clamping lever
Use the adjusting screw
limiter so the grinding disc
tact with the gullet (see Fig. D2). Fix the
grinding depth with the adjusting nut
Sharpening:
Switch on the product (see chapter "Switch-
ing on and off").
Sharpen the cutting tooth
grinding head
2
pressure to the handle
Never brake the grinding disc
stop. To prevent this, reduce the pressure
being applied in due time.
Switch the product off to move the saw
chain along. Loosen the clamping lever
and use the set stop
lever to secure the next link to be sharp-
ened in the chain guide
Note: First sharpen the teeth on one side
of the chain. Then adjust the sharpening an-
gle and sharpen the teeth on the other side.
Checking the depth limiter distance
(see Fig. D3):
The cutting parts of the saw chain are the cut-
ting links, consisting of a cutting tooth
depth limiter nose . The height distance be-
28
tween these two determines the depth limiter
distance A.
Check the depth limiter distance A accord-
ing to saw chain manufacturer specifica-
tions after every third sharpening.
Rasp the height of the depth limiter nose
with a flat file and slightly round after re-
moving the depth limiter nose. The original
shape must be maintained.
12 GB/CY
with the ad-
14a
by
7
clockwise.
13
to set the depth
6
makes con-
18a
.
6
by moving the
27
down, applying light
.
4
to a
18a
13
and the clamping
15
.
7
and a
27

Maintenance and cleaning

Always unplug from the mains
before any adjustment, service
or repairs.
Have any work not described in these in-
structions for use performed by a specialist
workshop. Always use original parts. Allow
the product to cool down before perform-
ing any maintenance or cleaning. Risk of
burns.
Check the product for any damage such as
loose, worn or damaged parts, correctly
fastened screws or other parts, before every
use. Particularly inspect the grinding disc
Replace any damaged parts.

Cleaning

Do not use cleaners or solvents. Chemicals
may damage plastic parts on this product.
Never clean the product under running
water.
Clean the product after every use.
Clean the vents
product with a soft brush or a cloth.
Clean the chain guide
If very dirty, loosen the chain tensioner
locking nut
tensioner with rotary table
access. We recommend removing the side
panels for cleaning.
Replacing the grinding
disc (see Fig. E)
Information about replacing the
28
grinding disc:
Never operate the product without the
visual cover
Verify the speed specified on the grinding
disc is equal to or greater than the
18a
rated idle speed of the product. Verify the
dimensions of the grinding disc fit the product.
and the surface of the
21
with a brush.
7
and remove the chain
10
for better
12
.
20
.
18a