ESX QUANTUM QXB6A Bedienungsanleitung Seite 24

TROUBLE SHOOTING
ATTENTION: All instructions in this troubleshooting refer to the entire sound system and its individual com-
ponents. The features of your device may not match the functions described in the notes. Then skip this point
and move on to the next one.
NO FUNCTION / THE POWER LED IS NOT ILLUMINATED
First check the fuse of the routed power cable on the vehicle battery
The fuse is defective
Replace the defective fuse with an equivalent one, never with a higher value.
• The fuse fails again.
In this case there appears to be a short circuit between the fuse and the amplifier module. To do this, check
the + 12V power cable along its entire length from the battery to the amplifier module for damage and
whether there is a short circuit to ground, e.g. a contact with the vehicle chassis or the body. If necessary,
replace the defective power cable.
The fuse is apparently okay
Use a standard 12 volt voltmeter to check the voltage between the + 12V connection and the ground connection
on the amplifier module.
• There is no voltage.
Use the voltmeter to check the fuse, which is located close to the vehicle battery, to see whether there is
voltage between the output and ground.
If there is no voltage there, either the fuse holder or the fuse is defective, although it appears to be okay. If
necessary, replace the fuse holder or fuse.
• There is voltage.
If you operate the amplifier module with a pre-amplifier module signal (RCA), you must have laid a remote
turn-on wire from the head unit to the REM terminal of the amplifier module. The AUTO TURN-ON switch
must be in the OFF position. However, you can test the AUTO TURN-ON switch to SIGNAL to see if the
amplifier module then turns on. If so, there is a problem with the control line..
• A remote turn-on wire is connected to the REM terminal at the amplifier module.
Use the voltmeter to check whether there is voltage between the REM terminal of the amplifier
module and ground. The head unit must be switched on.
There is no voltage.
• Check the remote turn-on wire from the amplifier module to the head unit for a short circuit or
damage. If necessary, replace the control line..
There is voltage.
• The amplifier module is probably malfunctioning or defective. Contact your retailer.
If you operate the amplifier module with the loudspeaker signals (high level mode), the AUTO TURN-ON
switch must be switched to DC.
• The AUTO TURN-ON switch is in the DC position, but the amplifier module remains off.
Check the speaker cables from the head unit to the amplifier module for short circuits or damage. If
necessary, replace the speaker cables or insulate the damaged area.
24