Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
STAND-ALONE MODE
-
Sound Control / Sensitivity
-
DMX MODE
-
2CH
-
Stand-Alone mode
Sound control/ sensitivity
Press the MODE/ESC button until the display shows S-- , you can select the desired sensitivity via the UP or
DOWN buttons, S S00-S100 (S50 default).
DMX-mode
The device has different DMX channel modes. The Control Board allows you to assign the DMX channel
mode and the DMX fixture address, which is defined as the first channel from which the device will respond
to the controller.
Addressing
Press the MODE/ESC button until the display shows "d--". You can now set the desired address via the UP
or DOWN buttons. Press ENTER to confirm.
Please, be sure that you don't have any overlapping channels in order to control each device correctly and
independently from any other fixture on the DMX-chain. If several devices are addressed similarly, they will
work synchronically.
Controlling:
After having addressed the device, you may now start operating it via your lighting controller.
Please see the following DMX protocol graphics for the respective channel values.
DMX-protocol
Channel 1: Dimmer
Value:
000 – 255
UV (0 – 100%)
Channel 2: Sound control and Strobe
Value:
000 – 000
No function
001 – 005
Sound Control
006 – 010
No function
011 – 255
Strobe (increasing speed)
CLEANING AND MAINTENANCE
We recommend a frequent cleaning of the device. Please use a soft lint-free and moistened cloth. Never use
alcohol or solvents!
There are no serviceable parts inside the device except for the fuse. Maintenance and service operations are
only to be carried out by authorized dealers.
Replacing the fuse
If the fine-wire fuse of the device fuses, only replace the fuse by a fuse of same type and rating.
Before replacing the fuse, unplug mains lead.
Function:
Function:
DANGER TO LIFE!
Disconnect from mains before starting maintenance operation!
19/20
00085093, Version 1.0
Werbung
Inhaltsverzeichnis
