TOOLCRAFT LDM 50 T Bedienungsanleitung Seite 41

Display unit (F2)
1. Press and hold the button "Settings" for approx. two seconds. When
releasing the button, "F1" will be shown on the display.
2. Press the button "Settings". The display will show "F2".
3. Press buttons "+" or "-" to change the display unit.
4. The relevant indicator will be shown in the bottom right corner of
the display.
5. The following units can be selected:
Meter
Length
Area
Volume
6. Press the button "Settings" to confirm.
7. Press the button "On/Off" to exit the Settings menu.
Setting stake out points (F3)
1. Press and hold the button "Settings" for approx. two seconds. When
releasing the button, "F1" will be shown on the display.
2. Press the button "Settings" twice. The display will show "F3".
3. Press buttons "+" or "-" to set the stake out point. To fast forward
through the values, press and hold the relevant button.
4. Press the button "On/Off" to reset the value to "0".
5. Press the button "MEAS" to toggle between the position before and
after the decimal point.
6. Press the button "Settings" to confirm.
7. Press the button "On/Off" to exit the Settings menu.
Feet
m ft
m² ft²
m³ ft³
Inch
in
ft
2
ft
3
41