Usage; Switching On The Air Cleaner; Fan Speed; Ioniser/Sleep Mode - Beurer LR 210 Gebrauchsanweisung

7. Usage

7.1 Switching on the air cleaner

1. Always follow the instructions in chapter "Initial use".
2. Insert the mains plug into the socket. Ensure that the cable does not pose a trip hazard.
3. Press the ON/OFF button (
Note
When starting up for the first time, all of the LEDs initially light up. The air cleaner is then set to the lowest
fan speed and the ioniser is activated.
Note
If the "Filter reset" light above the on/off button is flashing, you must replace the combi filter. To do this,
follow the instructions in the "Filter change" section.

7.2 Fan speed

The air cleaner has three fan speeds: I (low), II (medium) and III (high).
• To switch between the individual fan speeds, press the fan speed button
set lights up on the control panel.

7.3 Ioniser/Sleep mode

1 x press
2 x press
3 x press
4 x press
If sleep mode is activated, all the LEDs in the operating panel automatically switch off after 10 seconds.
To deactivate sleep mode, press any button on the operating panel.

7.4 Timer function

The air cleaner features a timer function that you can use to determine the number of hours the air cleaner
should run for before it automatically switches itself off. The air cleaner has three timer periods: 2H (two hours),
4H (four hours) and 8H (eight hours).
• To switch between the individual timer periods, press the TIMER button (
currently set lights up on the control panel. The air cleaner will now automatically switch off after the set
number of hours has passed.
• To switch off the timer, repeatedly press the TIMER button (
out. The air cleaner will now clean for an unlimited period.
) to switch on the air cleaner.
Ioniser Sleep mode
ON OFF
ON ON
OFF ON
OFF OFF
Note
„ION" LED illuminates
„ION" LED illuminates
„Sleep" LED flashes
„ION" LED goes out
„Sleep" LED flashes
„Sleep" LED goes out
), until the light above the TIMER button goes
17
. The fan speed that is currently
) The TIMER period that is