Herunterladen Inhalt Inhalt Diese Seite drucken

SOMFY 9028474 Bedienungsanleitung Seite 28

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 13
CONNECTING AND FASTENING THE ASSEMBLY
• Check that your video door phone is still powered off.
• Strip the previously identified power supply and
call station cables over a length of 10 mm.
• On the back of the monitor connectivity
module, insert the 2 power supply cables up to
the stop blocks on terminal block DC 24V [1],
observing the correct polarity.
Reminder: do not hesitate to use the photo
taken at the start of the installation process.
• Insert the 2 call station power supply cables up to the stop blocks on terminal block CS/Call station [2].
The polarity is irrelevant.
• Check that the cables are correctly inserted into the terminal blocks by pulling on them gently, then fit them in the specially
provided notch [3]. If the cables (power supply/call station) do not protrude from the wall, do not route them via the
mounting bracket, use the specially provided cable tray [4].
1
2
• Fasten the assembly on the mounting bracket by
sliding it gently downwards onto the stop block.
POWERING ON THE INSTALLATION
• When installation is complete, power on your
connected video door phone.
The monitor screen and the operating LED situated
on the edge of the connectivity module are lit.
The settings previously made on the monitor are
retained.
25
1
3
-
+
3
4
LED

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis