Haier HCR5919ENMM Bedienungsanleitung Seite 14

Use
Select the working mode
You may need to select one of the following two ways to set the appliance:
1) Auto Set mode
Under Auto Set mode, the appliance can automatically adjust the temperature setting
according to the ambient temperature and temperature change in the appliance. If you
do not have any special requirements, we recommend that you use Auto Set mode
(refer to Auto Set mode later on).
2) Manual adjusting mode:
If you want to manually adjust the temperature of the appliance in order to store
a particular food, you can set the temperature via a temperature adjusting button (refer to
ADJUST THE TEMPERATURE).
14
Door opening alarm
When the refrigerator door is opened for more than
1 minute, the door opening alarm will sound. The alarm
can be silenced by either closing the door or touching
the control panel. If the door is left open for more than
7 minutes, the light inside the compartment and control
panel illumination will automatically switch off.
Adjust the temperature
The indoor temperatures are influenced by the
following factors:
 Ambient temperature
 Frequency of door opening
 Amount of stored foods
 Installation of the appliance
Adjust the temperature for fridge
1. Unlock the panel by pressing button "F" if it is locked.
2. Press button „A" (Fridge) for select the fridge
compartment. An alarm sounds. The actual
temperature in the refrigerator compartment
is displayed.
3. Press button "A" to set the fridge temperature.
A signal will sound at each key press.
The temperature down shifts in sequences
of 1°C from the set temperature to 1°C,
switching to 9°C again when pressing further.
The optimum temperature in the refrigerator
is 4°C. Colder temperatures mean unnecessary
energy consumption.
If no key is operated in 5 sec., the setting confirms
automatically.
EN