Hilti DX 6 Original Bedienungsanleitung Seite 33

In addition, be sure to study all the notes on operation in the app. This will give you a better overview
of how the connection is made and how the functions are used.
3.6 Information about the app
To find out more about the app, to download it and start it, scan the QR code in the case.
3.7 Requirements to be met by cartridges
WARNING
Risk of injury by unexpected explosion!
requirements can lead to a build-up of unburned powder. A sudden explosion and severe injuries to the
operator and bystanders can result.
▶ Use only cartridges that meet the minimum safety requirements of your local statutory regulations!
▶ Adhere to the maintenance intervals as stated and have the fastening tool cleaned regularly by Hilti-
Service!
Use only the Hilti DX cartridges listed in this table, or other suitable cartridges that are compliant with the
minimum safety requirements:
• It is a requirement for EFTA countries that the cartridges must be CE-compliant and must bear the CE
mark of compliance.
• It is a requirement for the United Kingdom that the cartridges must be UKCA-compliant and must bear
the UKCA mark of compliance.
• It is a requirement for the USA that the cartridges must be compliant with the stipulations set out in
ANSI A10.3-2020.
• It is a requirement for the non-European member states of the C.I.P. that the cartridges must have C.I.P.
approval for the DX fastening tool used.
• It is a requirement for the remaining countries that the cartridges must have passed the firing-residues
test in accordance with EN 16264 and must have a manufacturer's declaration to this effect.
Cartridges
Ordering designation
DX 6 cartridge
DX 6 cartridge
3.8 Minimum distances and edge distances
You must always observe certain minimum distances and spacing when driving fasteners. They can differ,
depending on the product.
Comply with the instructions for use in the operating instructions of the fastener used, in the Hilti
Direct Fastening Technology Manual or the corresponding local Hilti 'Technical Guide to Fastening
Technology'.
Fastening to concrete or steel
Description
minimum distance from the edge of the base material to the
fastener
minimum center-to-center distance between fasteners
minimum base-material thickness
3.9 Information about the field of applications
See the Hilti product page for more information about the areas of application.
*2232121*
Use of cartridges that do not meet the minimum safety
2232121
Color Power level
titanium-gray strong
black extra-strong
Concrete Steel
≥ 70 mm ≥ 15 mm
≥ 80 mm ≥ 20 mm
≥ 100 mm Follow the instruc-
tions in the operat-
ing instructions of
the fastener!
English 25