EUROM Alutherm Wi-Fi Black 1500 Bedienungsanleitung Seite 27

1. Make sure the ON/OFF switch is in the OFF
position (Figure 13, pos. 3)
2. Connect the temperature sensor connector
(Figure 13, pos. 2) to the sensor plug (Figure
13, pos. 1).
3. Place the temperature sensor approximately
2 meters away from the device.
Installation
WARNING
Do not put the power plug into the wall socket before the device is correctly
mounted or stands in the right place.
Do not use an extension cable; this can cause overheating and fire. If using an
extension cable is unavoidable, make sure it is undamaged and earthed. Use
an extension cable with a minimum power of 2500 Watt. Always unwind the
extension cable completely to prevent overheating.
CAUTION
Make sure that the main voltage is the same as indicated on the identification
label of the device. All electrical connections must stay dry under all
circumstances.
1. Make sure the device is correctly assembled.
2. Make sure the ON/OFF switch is in the OFF
position (Figure 14, pos. 1).
3. Place the power plug (Figure 14, pos. 2) into
an earthed wall socket that is easily
accessible. Use an earthed wall socket with a
minimum power of 2500 Watt.
Figure 13
Figure 14
27