Inhaltsverzeichnis
Werbung
Anleitung HS 550 SPK 1
27.10.2005
26.
Do not use the hedge trimmer with a damaged
or excessively worn cutting system.
27.
Never try to work with an incomplete machine
or a machine with unapproved modifications.
28.
Check your surroundings and take note of any
potential dangers which you may not be able
hear due to the machine's noise.
29.
It is advisable not to use the hedge trimmer
when other persons, and particularly children,
are nearby.
30.
Children are not allowed to use the hedge
trimmer.
31.
Noise at the workplace may exceed 85 dB(A).
In this case, the operator must wear ear-muffs
or similar. The noise level of this electric tool is
measured in accordance with IEC 59 CO 11;
IEC 704; DIN 45635-1, D.3.1; and NFS 31-031
(84/537 EWG).
32.
Vibrations on the handle were measured in
accordance with EN 50144-2-15.
33.
Please use an RCD with this unit.
2. Layout (see Fig. 1)
1. Cutter rail
2. Hand guard
3. Steady grip with button switch
4. Handle with button switch
5. Stress-relief clip
6. Power cable
7. Cutter guard
Important! You must never use the hedge trim-
mer without wearing gloves.
3. Explanation of the plate (see Fig. 3)
1. Warning
2. Keep out of the rain and protect from getting wet.
3. Read the operating instructions before using for
the first time.
4. Pull the plug from the power supply immediately
if the cable gets damaged or severed.
5. Wear goggles and ear muffs.
4. Technical data
Mains connection
230 V ~ 50 Hz
Power input
Cutting length
Cutter rail length
15:58 Uhr
Seite 13
Tooth spacing
Cuts/min
Cutting thickness max.
LWA sound power level
LPA sound pressure level
Vibration a w :
Weight
5. Mains connection
The machine may only be operated with single-phase
alternating current from a 230V AC 50Hz supply.
Before you use the machine, make sure that the
mains voltage complies with the specifications on the
rating plate.
6. Start-up and operation
Important! This hedge trimmer is suitable for cutting
hedges, bushes and shrubs. Any use which is not
expressly permitted in manual may result in damage
to the hedge trimmer and place the user in serious
danger.
The hedge trimmer is equipped with a two-handed
safety switch.
The machine works only when the switch on the
steady grip (Figure 2 / Item 1) is pressed with one
hand and the switch on the handle (Figure 2 / Item 2)
is pressed with the other hand.
If either switch is released, the cutters will stop mov-
ing.
Please watch out for the cutters as they slow
down to a standstill.
- Please check that the cutters work properly. The
twin-bladed cutters rotate in opposite directions,
thus guaranteeing high cutting performance and
smooth operation.
- Before use, fasten the extension cable in the
stress-relief clip (see Fig. 4).
- When working outdoors, use extension cables that
are approved for the purpose.
7. Notes on working practice
A hedge trimmer can be used to cut shrubs and
bushes as well as hedges.
550 watts
To obtain the best cutting results, hold the hedge
trimmer so that the cutter teeth are at an angle of
465 mm
approx. 15° in relation to the hedge (see Figure
540 mm
5).
GB
18 mm
3200
14 mm
99 dB(A)
84.4 dB(A)
2.2 m/s
2
3.0 kg
13
Werbung
Inhaltsverzeichnis
