Air Pressure Test; Disposal And Recycling; Cleaning, Maintenance And Ordering Of Spare Parts - EINHELL CC-AC 35/10 12V Originalbetriebsanleitung

7. Air pressure test

This function is intended for car tires and bicycle
tires. The compressor does not need to be swit-
ched on. Proceed as described in section 6.2. The
air pressure can be read off the pressure gauge.
In the case of items where the wrong pressure
might be fatal, e.g. car tires, the pressure should
be checked with a calibrated pressure gauge.
8. Cleaning, maintenance and
ordering of spare parts
Danger!
Always pull out the 12V power plug before starting
any cleaning work.
8.1 Cleaning
•
Keep all safety devices, air vents and the
motor housing free of dirt and dust as far as
possible. Wipe the equipment with a clean
cloth or blow it with compressed air at low
pressure.
•
We recommend that you clean the device
immediately each time you have finished
using it.
•
Clean the equipment regularly with a moist
cloth and some soft soap. Do not use
cleaning agents or solvents; these could at-
tack the plastic parts of the equipment. Ensu-
re that no water can seep into the device. The
ingress of water into an electric tool increases
the risk of an electric shock.
8.2 Maintenance
There are no parts inside the equipment which
require additional maintenance.
8.3 Ordering replacement parts:
Please quote the following data when ordering
replacement parts:
•
Type of machine
•
Article number of the machine
•
Identification number of the machine
•
Replacement part number of the part required
For our latest prices and information please go to
www.isc-gmbh.info
Anl_CC_AC_35_10_12_V_SPK7.indb 11 Anl_CC_AC_35_10_12_V_SPK7.indb 11
GB

9. Disposal and recycling

The equipment is supplied in packaging to pre-
vent it from being damaged in transit. The raw
materials in this packaging can be reused or
recycled. The equipment and its accessories are
made of various types of material, such as metal
and plastic. Never place defective equipment in
your household refuse. The equipment should
be taken to a suitable collection center for proper
disposal. If you do not know the whereabouts of
such a collection point, you should ask in your
local council offi ces.
10. Storage
Store the equipment and accessories in a dark
and dry place at above freezing temperature. The
ideal storage temperature is between 5 and 30
°C. Store the electric tool in its original packaging.
- 11 -
14.09.2016 11:12:14 14.09.2016 11:12:14