Toshiba RAS-B10N3KV2-E1 Benutzerhandbuch Seite 4

1 INDOOR UNIT DISPLAY
4 5
1 2 3
6
PREPARATION BEFORE USE
2
Preparing Filters
1. Open the air inlet grille and remove the air fi lters.
2. Attach the fi lters. (see detail in the accessory sheet).
Loading Batteries (when use wireless operation.)
1. Remove the slide cover.
2. Insert 2 new batteries (AAA type)
following the (+) and (–) positions.
Clock Setup
1. Push by tip of the pencil.
If timer indication is fl ashing, go to the next step 2.
2. Press or : adjust the time.
3. Press : Set the time.
Remote Control Reset
Push by tip of the pencil or
1. Remove the batteries.
2. Press .
3. Insert the batteries.
3 AIR FLOW DIRECTION
1
Press : Move the louver in
the desired vertical direction.
2
Press : Swing the air
automatically and press again to stop.
For horizontal direction, adjust
3
manually.
Note:
• Do not move the louver manually by others.
• The louver may automation positioning by some operation mode.
4 REMOTE CONTROL
1 Infrared signal emitter
2 Start/Stop button
3 Mode select button (MODE)
4 Temperature button (TEMP)
5 Fan speed button (FAN)
6 Swing louver button (SWING)
7 Set louver button (FIX)
8 On timer button (ON)
9 Off timer button (OFF)
! Setup button (SET)
" Clear button (CLR)
# Memory and Preset button (PRESET)
$ One-Touch button (ONE-TOUCH)
% High power button (Hi-POWER)
& Economy button (ECO)
( Quiet button (QUIET)
) Comfort sleep button (COMFORT SLEEP)
~ Filter reset button (FILTER)
+ Set clock button (CLOCK)
, Check button (CHECK)
- Reset button (RESET)
Note:
• The provided Remote Controller is a wireless type, which also can be
used as a wire. Please see "How to Connect The Remote Controller
for Wired Operation", located in installation instruction, in case of wired
control is required.
• In wire operation, remote controller will return to initial condition
(PRESET, TIMER and CLOCK will return to initial condition) when user
shutdown power supply of Air conditioner.
1 Hi POWER (Green)
2 FILTER (Orange)
3 PRE.DEF (Preheat/Defrost) (Orange)
4 TIMER (Yellow)
5 OPERATION (Green)
6 RESET button
1
#
2
3
SWING FAN
7
$ ONE-TOUCH FIX QUIET
&
Hi POWER
COMFORT
8
SLEEP
)
,
+
5 ONE-TOUCH
Press the "ONE-TOUCH" button for fully automated operation that is
customized to the typical consumer preferences in your region of the world.
The customized settings control temperature air fl ow strength, air fl ow
direction and other settings to provide you alternate contact with "ONE-
TOUCH" of the button. If you prefer other settings you can select from the
many other operating functions of your Toshiba unit.
Press : Start the operation.
AUTOMATIC OPERATION
6
To automatically select cooling or heating operation
1. Press : Select A.
2. Press : Set the desired temperature.
3. Press : Select AUTO, LOW , LOW+
MED+ , or HIGH
7 COOLING / HEATING OPERATION
1. Press : Select Cool
2. Press : Set the desired temperature.
Cooling: Min. 17°C, Heating: Max. 30°C
3. Press : Select AUTO, LOW , LOW+
MED+ , or HIGH
8 DRY OPERATION
For dehumidifi cation, a moderate cooling performance is controlled
automatically.
1. Press
2. Press
9 Hi-POWER OPERATION
To automatically control room temperature and airfl ow for faster cooling or
heating operation (except in DRY mode)
Press : Start and stop the operation.
10 ECO OPERATION
To automatically control room to save energy (except in DRY mode)
Press : Start and stop the operation.
Note: Cooling operation; the set temperature will increase automatically 1
degree/hour for 2 hours (maximum 2 degrees increase).
For heating operation the set temperature will decrease.
11 TEMPORARY OPERATION
4
In case of the misplaced or discharged remote control
• Pressing the RESET button, the unit can start or
6
stop without using the remote control.
5
• Operation mode is set on AUTOMATIC operation,
(
preset temperature is 24°C and fan operation is
%
automatic speed.
"
9
12 TIMER OPERATION
!
-
~
Set the timer when the air conditioner is operating.
Setting the ON Timer
1
Press : Set the desired ON
2
Press : Set the timer.
3
Press : Cancel the timer.
Daily timer allows the user to set both the ON & OFF timers and will be
activated on a daily basis.
, MED
.
, or Heat .
, MED
.
: Select Dry .
: Set the desired temperature.
Setting the OFF Timer
Press
timer.
Press
Press
,
,
: Set the desired
OFF timer.
: Set the timer.
: Cancel the timer.