Setting The Remote Control; Indication In Display (Standard °F/12-H); Time Setting; Basic Functions - Faber GV36TT Bedienungsanleitung

3.6

Setting the remote control.

3.6.1 Indication in display (standard °F/12-h):

Press the AUTO and TIMER buttons simultaneously, the display will be blinking
(fig. 1.4).

Now press the AUTO button to change the setting from °C/24-h to°F/12-h or vice
versa.

The remote control will go back to the normal setting in due time, but this can also
be done directly by pressing the TIMER button.
3.6.2

Time setting:


Press the AUTO and TIMER buttons simultaneously, the display will be blinking
(fig. 1.4).

Press the button to set the hours (fig.1.5).

Press the button to set the minutes (fig.1.6).

The remote control will go back to the normal setting in due time, but this can also
be done directly by pressing the TIMER button.
3.7

Basic functions.

3.7.1 Manuel:

Hold the -button pressed to increase the flame height continuously (fig 1.5).

Hold the -button pressed to reduce the flame height in stages and / or to switch
back to the pilot flame position (fig. 1.6).
IMPORTANT: By pressing the
on and the active thermostat and/or timer programmes are switched off.
3.7.2 Auto : Setting temperature

Press the AUTO button, the temperature indications in the display are now
blinking.

Press the button to increase the temperature setting (fig.1.5).

Press the button the decrease the temperature setting (fig.1.6).

The remote control will go back to the normal setting in due time.
- or the -button (fig. 1.5) the man operation is switched
24 < < < <