BRAYER BR1112 Bedienungsanleitung Seite 8

8 EN
cup is filled with water, press the button (15) «
» again to switch the water supply off and pour the
water out of the cup.
• Notes: - when you switch the water supply on for the
first time, some foreign noise of the operating pump
is possible, since air comes out of the boiler, after a
while the noise will disappear.
• Wait until the button (15) indicator stops flashing and
glows constantly, then switch the water supply on
by pressing the button (15) «
filled with water, press the button (15) «
to switch the water supply off and pour the water out
of the cup.
• Depending on the cup capacity repeat this procedure
several times until the boiler is clean.
ATTENTION!
• Do not remove the filter holder (4) during coffee
making.
• Do not remove the filter holder (4) immediately after
preparing coffee as there is redundant water and
steam pressure inside the filter (4), let the coffee
maker cool down completely.
• To remove the filter holder (4) turn the handle (3) to
the left «Insert» and remove the filter holder (4).
AUTO SWITCH OFF FUNCTION
• If no actions were performed during 25 minutes
after switching on, the coffee maker will switch off
automatically.
HOW TO MAKE A GOOD ESPRESSO
• Use ground coffee for espresso coffee makers.
• Slightly tamp the ground coffee in the filter (5), you
• Coffee strength depends on the quality and grinding
». After the cup is
PREHEATING
» again
• To make a cup of hot espresso, it is recommended to
• Open the lid (18) and fill the tank (19) with water, or
• Insert the filter (5) into the holder (4).
• Install the filter holder (4) into the coffee maker. The
• Place a suitable cup on the grid (2).
• Make sure that the steam supply is closed. To do this
• Insert the power plug into the mains socket.
• Switch the coffee maker on by pressing the on/off
can do it with the back side of the measuring spoon
(17 ).
degree of coffee beans. If coffee is pouring out too
long, this means the coffee powder is too fine or it is
tamped too strongly.
preliminary heat up the coffee filter (5) and the filter
holder (4).
remove the tank (19) and fill it with water, then install
the tank (19) back to its place.
holder (4) ledges should match the grooves on the
boiler «Insert», after that turn the filter holder handle
(3) to the right until bumping «Lock».
turn the knob (8) « » clockwise until bumping «•».
button (14) « », the button (14) indicator will
light up.