How To Use - Xiaomi S10 Benutzerhandbuch

How to Use

Start Vacuuming & Mopping
1. Take out the 2-in-1 dust compartment with water tank, open the plug,
fill with clean water, and then refasten the plug. Install the 2-in-1 dust
compartment with water tank onto the robot vacuum in the direction
indicated in the figure, and make sure that the clip is firmly clasped.
Clip
It is properly installed
when you hear a "click".
CAUTIONS:
Please remove the 2-in-1 dust compartment with water tank before adding water.
Do not add liquids such as hot water, detergent, or disinfectant to prevent
damaging the robot vacuum.
Due to production testing, the 2-in-1 dust compartment with water tank may have
water stains, which is normal.
2. Before using the vacuuming & mopping function, dampen the mop pad
and wring it out and then install it onto the mop pad holder. Slide the
mop pad holder along the bo om of the robot vacuum horizontally in
the direction indicated in the figure until it clicks into place.
① ②
Plug
Open the plug and
add water.
③
07
3. Press the bu on to start vacuuming and mopping.
CAUTIONS:
Remove the 2-in-1 dust compartment with water tank and pour out the le over
water in a timely manner a er a mopping task has been completed. Then clean and
dry the mop pad to prevent odor and mildew.
When the robot vacuum is running, please set up virtual walls or restricted areas
for carpeted areas in your home to avoid the robot vacuum from becoming
entangled in the carpet.
If only vacuuming function is needed, please remove the mop
pad holder.
Clips
Press the clips and pull
the mop pad holder out.