Display Icons - Topcom BPM WRIST 7500 Gebrauchsanweisung

TOPCOM BPM Wrist 7500
• When the measurement is completed, systolic, diastolic
and pulse will be shown simultaneously on the LCD
screen.
13.1

Display icons

• If the Systolic or Diastolic rate of the result is greater than
your pre-set personalized level (see chapter 9.3), the digit of Systolic or Diastolic
rate will flash.
• If the Systolic or Diastolic rate of the result is equal to or less than your pre-set
personalized level, the smiling face icon
• When a mistake was detected during measurement the Error icon
the display.
13.2 Irregular heartbeat (IHB)
The appearance of this symbol,
detected during measurement.
Talking, moving, shaking or an irregular pulse during the measurement can result in the
appearance of this icon.
Usually this is not a cause for concern, however if the symbol appears often, we
recommend you seek medical advice.
And please note that the device does not replace a cardiac examination, but serves to
detect pulse irregularities at an early stage.
The irregular heart beat detected record wont be stored in memory.
14 Memory
The BPM Wrist 7500 has 3 Memory zones. Each can store up
to 40 measurements including the date and time
The result will be stored automatically in the selected Memory
Zone after the measurement.
To recall measurement results:
• Press the START/STOP button to activate the display.
• Press the UP or DOWN button to select the desired
memory zone.
• Press the MEMORY button to see the average of all measurement results [A]
• Press the UP button repeatedly to see prior stored measurement results.
• To stop reading the data, press the START/STOP button to switch back to stand-
by.
10
will flash.
, signifies that a certain pulse irregularity was
appears on