Specifications - Makita JN3201 Bedienungsanleitung

ENGLISH (Original instructions)
1-1. Stainless steel gauge 2.5 mm
(3/32")
1-2. Mild steel gauge 3.2 mm (1/8")
2-1. Switch trigger
2-2. Lock button
3-1. Wrench
3-2. Lock nut
3-3. Die holder
4-1. Punch
4-2. Screw

SPECIFICATIONS

Max. cutting capacities
Min. cutting radius
Strokes per minute (min
• Due to our continuing program of research and development, the specifications herein are subject to change without notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
Intended use
The tool is intended for cutting sheet steel and stainless
sheet steel.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and
can only be operated on single-phase AC supply. They
are double-insulated and can, therefore, also be used
from sockets without earth wire.
Noise
The typical A-weighted
according to EN60745:
Sound pressure level (L
Sound power level (L
Uncertainty (K) : 3 dB(A)
Wear ear protection
Explanation of general view
4-3. Wrench
5-1. Cutting edge
5-2. Punch
5-3. Groove
5-4. Punch holder
5-5. Pin
8-1. Screw
8-2. Hex wrench
8-3. Washer
8-4. Insert washer in between
Model
Steel up to 400 N/mm
Steel up to 600 N/mm
Steel up to 800 N/mm
Aluminum up to 200 N/mm
Outside edge
Inside edge
-1
)
Overall length
Net weight
Safety class
noise level determined
) : 81 dB(A)
pA
) : 92 dB(A)
WA
2
2
2
2
ENE037-1
Vibration
The vibration
determined according to EN60745:
ENF002-2
Work mode : cutting sheet metal
Vibration emission (a
Uncertainty (K) : 1.5 m/s
The declared vibration emission value has been
•
measured in accordance with the standard test
method and may be used for comparing one tool
ENG905-1
with another.
The declared vibration emission value may also be
•
used in a preliminary assessment of exposure.
WARNING:
The vibration emission during actual use of the
•
power tool can differ from the declared emission
value depending on the ways in which the tool is
used.
Be sure to identify safety measures to protect the
•
operator that are based on an estimation of
exposure in the actual conditions of use (taking
account of all parts of the operating cycle such as
the times when the tool is switched off and when it
3
8-5. Die
9-1. Grind/sharpen; 0.3 - 0.4 mm
(1/64")
9-2. Remove dull portion
10-1. 3.5 -4.0 mm (1/8" - 5/32")
10-2. Die
10-3. Washer
11-1. Limit mark
12-1. Screwdriver
12-2. Brush holder cap
JN3201
3.2 mm / 10 ga
2.5 mm / 13 ga
1.0 mm / 20 ga
3.5 mm / 10 ga
128 mm
120 mm
1,300
225 mm
3.4 kg
/II
total value (tri-axial
2
) : 10.0 m/s
h
2
ENG900-1
vector sum)
ENG901-1