Setting The Clock And Day; Setting The Osc Period; Accepting The Preset Programme - Danfoss TP7000 Range Anleitung

Clock display (12 or 24 hr)
Press and hold NEXT & DAY (for 2-3 seconds)
until display change.
(AM or PM will appear in 12 hr mode)
1.5 Setting the Clock & Day
Press PROG to
DAY - Press DAY until correct day is shown
(1=Monday, 2=Tuesday etc).
TIME - Press + and - to change time (press
and hold to change in 10 min increments).
1.6 Setting the OSC Period, if enabled
This display will ONLY appear if the OSC
function has been enabled by your installer.
Use the + or - buttons to select the OSC
period. The choices are 0:30 (30 mins), 1:00
(1 hr), 1:30 and 2:00.
The recommended setting is 0:30. If set to
0:00 the function is disabled.
1.7 Accepting the preset programmes
If you are happy to use the preset programmes on page 6, you don't
need to do anything else. To accept these settings just close the
front cover and after 2 minutes the pre-settings will automatically be
accepted.
The unit is now in RUN mode (colon fl ashes
in display) and the heating will operate
according to the preset programmes.
Danfoss Heating
begin programming.
GB
F
D
ES
DK
NL
I
GR
PL
LT
CZ
HR
RO
7