Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
8. when finished, briefly press the
briefly press the
button again to register the baby unit on the parent
unit
9. now switch off this baby unit (briefly press and hold the
put it aside for the moment
additional baby units:
10. repeat steps 4 through 9 for all additional baby units
switch off:
11. after all baby units are registered according to the procedure above,
finally switch off the parent unit by briefly pressing and holding the
button
12. now switch on the parent unit and baby unit(s) in the usual way, as
described in paragraph 4.2.
6.2 OPERATION WITH MULTIPLE BABY UNITS:
•
When all babies are sleeping and the baby units
are all set to sleep mode, the parent unit will first
show the status of baby unit 1 (temperature, battery
indication, night light or lullabies are switched in,
etc.), after 15 seconds the status of baby unit 2, then
unit 3 and finally unit 4
This is repeated continuously for as long as all babies are sleeping (or
when quiet)
-
Unregistered baby units will be skipped.
-
When a baby unit is registered, but not in communication with the
parent unit (out of range, empty battery, switched off), the parent
unit will emit a warning signal. Only after the cause for this out-of-
range notification is cleared, will the parent unit switch over to the
next baby unit.
•
As soon as one of the babies starts crying, the parent unit will instantly
indicate the sound and status of the baby unit where the crying is
coming from. Don't forget that baby unit 1 always has the priority; this
means that when all babies are crying, the parent unit will indicate the
status of baby unit 1. The sequence is: baby-1, baby-2, baby-3, baby-4.
button to store the name and then
button) and
-
When several babies are crying, the status of the first crying baby is
shown in the display, but the display will indicate that another baby
is crying as well.
Brian is crying and his status is shown
while the sound is transmitted
Angel is crying as well
Now briefly press the
the above situation, the status and sound of Angel
are now transmitted).
•
For each baby unit, you can turn the night light on or off, turn the
lullabies on or off and activate the feeding timer (feeding intervals are
the same for all baby units). For turning these functions on or off and
talking back to the baby unit, the parent unit must be in communication
with the concerned baby unit (the name of this baby unit must be shown
in the display).
6.3 DEREGISTERING:
•
Defective baby units or units no longer in use must be erased from
the parent unit's memory to prevent the parent unit from constantly
indicating an out-of-range error for that baby unit. You can do this by re-
registering the baby units that are still in use. Only the baby unit you're
no longer using should not be re-registered.
It is not possible to deregister a specific baby unit at the parent unit.
47
button to switch priority (in
Werbung
Inhaltsverzeichnis
