Inserting/Replacing The Batteries - Westfalia 94 54 55 Originalanleitung

Inserting/Replacing the Batteries

The lamp is powered by three batteries of the type LR03 (AAA). The
battery compartment is integrated into the bottom of the lamp.
Replace the batteries when the light gets weaker.
1. Turn the base plate slightly counter clockwise and take it off the
lamp.
2. Insert three new batteries of the type LR03 into the battery
compartment. Pay attention to the proper polarity of the
batteries. The polarity is printed inside the battery compartment.
Reattach the base plate and lock it in place with the bayonet
latch.
Operation
You can set the switch on the back side of the lamp to the positions
ON, OFF and AUTO.
In the ON Position the lamp is turned on continuously, in the OFF
Position the lamp is turned off.
In the AUTO Position the lamp turns on in darkness
(<8 lux) as soon as the motion sensor is triggered and remains on for
approximately 30 seconds after the last motion has been detected.
With the magnet at the bottom, you can stick the lamp to any
magnetic surface.
INSTRUCTION
7