Installation Instruction - Klarstein BARZONA 2 Bedienungsanleitung

EN
14

INSTALLATION INSTRUCTION

1. After opening the carton, fix four legs on the four square yard by nuts as
followings show.
2. Clean the labels, put the trivets on correct positions.
3. Take off the dust proof cap of the gas inlet which located at the back side of
the stove, connect the gas pipe to the inlet, then fasten the connection by
turning the clamp clockwise.
WARNING: DANGER OF BODY INJURY AND EVEN DEATH:
Make sure the supplied gas and pressure is the same as label
marked.
4. Check leakage, turn the knob to" off " position, put soap water on connectors
of gas hose, then open the gas valve, bubbles indicate leakage if found. You
need to check the gas connection again then re-check the leakage.
WARNING: DANGER OF EXPLOSION
Leakage must be checked at the first use, never use the stove
without leakage check.
• The distance between the products be put around and stove should be more
than 15 cm, there should be more than 100 cm space above the stove.
• The distance between stove and cylinder should be around 1m, the proper
length of inlet gas hose is 1 m-2 m. One side of the hose connect the cylinder,
the other side connect the gas inlet hole of stove, the hose can not contact the
stove and thrill through the bottom of the stove, can not bend it forcedly.
• Both left and right burner of the stove can be used to heat convex bottom
utensils or pans (cookers),proper diameter of convex bottom utensil is 32 cm,