Inserting And Removing The Battery; Turning On And Off; Inserting Drill Or Screw Bits - Westfalia 17 86 40 Bedienungsanleitung

When inserting the battery into the charger, make sure it can be easily
inserted. Do not use force.
Please note that the battery and the charger can warm up slightly bit
during charging.
4. The charging LED (13) turns off and the power LED (14) shines green
when the charging process is finished. Remove the battery and unplug the
power cord from the wall socket.

Inserting and Removing the Battery

1. Slide the battery (7) into the bottom side of the
cordless drill and connect the terminals of the
battery and the cordless drill.
2. When inserting the battery, make sure it can
be easily placed. Do not use force.
Slide the battery as far as it will go until the
locking clips (6) audibly snap in.
3. For removing the battery, press both locking clips and slide the battery out
of the machine.

Turning ON and OFF

1. To turn the unit on, press the ON/OFF trigger (5). To turn off the cordless
drill, release the trigger.
2. The ON/OFF trigger is also used to control the rotation speed. The deeper
the trigger is pressed, the faster the unit runs. When the machine is turned
on, the LED work light (3) shines.
3. By pressing the rotating direction button (4) the rotating direction can be
reversed. In the middle position the ON/OFF trigger is locked. Set the
switch in this position when laying down the machine to avoid an
accidental start-up.
4. The rotating direction button can only be pressed, while the ON/OFF
trigger is released.

Inserting Drill or Screw Bits

Please note! Before changing drill bit and screw bit, set the rotating direction
button (4) into the middle position to avoid unintentional start-up.
The cordless drill has a keyless quick drill chuck (1) so you do not need a key
to lock the tool bit in place. Make sure that the drill or screw bit is not jammed
when you insert the tool and tighten the chuck.
Operating
12