Working Advice; Maintenance And Service; Maintenance And Cleaning - Bosch PSB 530 RA Originalbetriebsanleitung

OBJ_BUCH-379-003.book Page 24 Monday, October 5, 2009 9:57 AM
24 | English
Right Rotation: For drilling and driving in
screws, push the rotational direction switch 8
left to the stop.
PSB 600 RE/PSB 650 RE/PSB 650 RA: Rota-
tion direction indicator 4 indicates the symbol
" ".
Left Rotation: For loosening and unscrewing
screws and nuts, press the rotational direction
switch 8 through to the right stop.
PSB 600 RE/PSB 650 RE/PSB 650 RA: Rota-
tion direction indicator 4 indicates the symbol
" ".
Setting the Operating Mode
Drilling and Screwdriving
Set the selector switch 3 to the "Drill-
ing" symbol.
Impact Drilling
Set the selector switch 3 to the "Im-
pact drilling" symbol.
The selector switch 3 engages noticeably and
can also be actuated with the machine running.
Switching On and Off
Before switching the machine on again,
take care that the spindle lock button 2 is
no longer pressed in. The spindle lock but-
ton 2 can be released by turning the keyless
chuck 1.
To start the machine, press the On/Off switch 6
and keep it pressed.
To lock the pressed On/Off switch 6, press the
lock-on button 5.
To switch off the machine, release the On/Off
switch 6 or when it is locked with the lock-on
button 5, briefly press the On/Off switch 6 and
then release it.
Adjusting the Speed/Impact Frequency
The speed/impact rate of the switched on pow-
er tool can be variably adjusted, depending on
how far the On/Off switch 6 is pressed.
Light pressure on the On/Off switch 6 results in
low speed/impact rate. Further pressure on the
switch increases the speed/impact rate.
2 609 004 192 | (5.10.09)
Preselecting the Speed/Impact Frequency
(PSB 600 RE/PSB 650 RE/PSB 650 RA)
With the thumbwheel for speed preselection 7,
the required speed/impact frequency can be
preselected even during operation.
The required speed/impact frequency depends
on the material and the working conditions, and
can be determined through practical testing.

Working Advice

Apply the power tool to the screw/nut only
when it is switched off. Rotating tool inserts
can slip off.
After longer periods of working at low speed, al-
low the machine to cool down by running it for
approx. 3 minutes at maximum speed with no
load.

Maintenance and Service

Maintenance and Cleaning

Before any work on the machine itself, pull
the mains plug.
For safe and proper working, always keep
the machine and ventilation slots clean.
If the machine should fail despite the care taken
in manufacturing and testing procedures, repair
should be carried out by an after-sales service
centre for Bosch power tools.
In all correspondence and spare parts order,
please always include the 10-digit article
number given on the type plate of the machine.
After-sales Service and Customer
Assistance
Our after-sales service responds to your ques-
tions concerning maintenance and repair of your
product as well as spare parts. Exploded views
and information on spare parts can also be
found under:
www.bosch-pt.com
Our customer service representatives can an-
swer your questions concerning possible appli-
cations and adjustment of products and acces-
sories.
Bosch Power Tools