Operation Using Keypad And Control Terminals; Frequency Set By External Source And Run/Stop By Keypad - LG SV008iS5-2 Bedienungsanleitung

3.3 Operation using Keypad and Control Terminals

3.3.1

Frequency set by External Source and Run/Stop by Keypad

1. Install a potentiometer on terminals V1, VR, 5G and connect wiring as shown below left.
When a '4 to 20mA' current source is used as the frequency reference, use terminals I and 5G as shown
below right.
DRV 04 must be set at V1.
P1 P2 P3 FX RX NC
JOG CM
CM BX
2. Apply AC power.
3. LCD: Press ▲ key to move DRV 03.
7-Seg: Rotate encoder knob until '03' is
displayed.
4. LCD: Press PROG key.
7-Seg: Press PROG/ENT key.
5. LCD: Press ▲ key one time.
7-Seg: Rotate encoder knob and set at '0'.
6. LCD: Press ENT key.
7-Seg: Press PROG/ENT key.
7. Confirm that the DRV 04 is set at 'V1'.
8. Press SHIFT/ESC key.
Set the frequency by rotating the
potentiometer.
9. LCD: Press FWD or REV key.
7-Seg: Press RUN key.
All manuals and user guides at all-guides.com
1 ㏀, 1/2 W
VR VI
RST
I FM 5G
DRV►T/K
00
DRV► Drive mode
03
DRV► Drive mode
03
DRV► Drive mode
03
DRV► Drive mode
03
DRV►
04
DRV►T/V
00
The FWD or REV LED starts blinking.
DRV 04 must be set at I.
P1 P2 P3 FX RX NC
JOG CM
CM BX
0.0 A
STP 0.00Hz
Fx/Rx-1
Fx/Rx-1
Keypad
Keypad
Freq mode
V1
0.0 A
STP 60.00Hz
34
Chapter 3 - Quick Start Up
VR VI
RST
I FM 5G
4 to 20mA signal
The DRV LED is ON.
The PROG/ENT LED is turned ON.
The PROG/ENT LED is turned ON.
The PROG/ENT LED is turned OFF.
The PROG/ENT LED is turned ON.
The RUN LED starts blinking.
To change the motor running
direction, change DRV 13 to '1'.