Electrical Safety - Parkside PHLGD 2000 A1 Originalbetriebsanleitung

- Be careful when using the
devices near flammable ma-
terials.
- Do not point at the same
location for an extended pe-
riod of time.
- Do not use in the presence of
an explosive atmosphere.
- Heat can be passed to flam-
mable materials that are hid-
den.
- After using the device, put
it on the stand and allow
it to cool down before it is
packed away.
- Do not leave the device un-
attended as long as it is in
operation.
• If in danger, immediately re-
move the mains plug from the
socket.
• Never use the device as a hair
dryer.
• Never direct the hot air flow at
people or animals.
• Do not look directly into the
nozzle opening on the blow-off
pipe.
• Do not touch the nozzle when it
is hot.
• Maintain distance between the
nozzle outlet and the surface or
workpiece you are working on.
The device could overheat.
Use as a solid fuel lighter /
use of the grill lighter nozzle
(10)
• Check that the solid fuel lighter
is in the correct position.
• Isolate from the mains before
removing it from the fire.
• Allow the solid fuel lighter to
cool down before packing it
away.
• The connection cable or other
flammable materials must not
come into contact with the hot
parts of the solid fuel lighter.
Caution: This is how to avoid
accidents and injuries by an
electric shock:

Electrical safety

• Make sure that the mains volt-
age matches the details on the
type plate.
• Connect the device only to a
socket with a residual current
circuit breaker (Residual Current
Device) with a tripping current
of not more than 30 mA.
• Do not use the mains cable to
pull the plug from the socket.
Protect the mains cable from
heat, oil and sharp edges.
• Switch the device off and pull
the mains plug out of the socket
if the mains cable is damaged.
If the connection cable of this
device is damaged, it must be
replaced by the manufacturer
or their customer service or by
a similarly qualified person in
order to avoid hazards.
• Do not connect a damaged
mains cable to the power sup-
ply. Do not touch a damaged
mains cable as long as it is
connected to the power supply.
A damaged mains cable can
result in voltage-carrying parts
being touched.
GB MT
37