Danger Of Burns - Kärcher MC 130 Plus Bedienungsanleitung

Wheel nuts
1
Wheel
2
1. Park the vehicle on level and solid ground.
2. Engage the parking brake and additionally secure the vehicle
against rolling away.
3. Secure the articulated joint.
4. Remove the ignition key.
5. Use a suitable tool to release the wheel nuts by approx. 1 turn.
6. Fit the jack to the appropriate mounting point at the front or
rear wheel and raise the vehicle with the jack.
7. Additionally support the vehicle with axle stands or blocks.
8. Unscrew the wheel nuts.
9. Remove the wheel.
10.Fit the new wheel and tighten all wheel nuts in a diagonal se-
quence all the way to their end stops.
11.Tighten the wheel nuts to a torque of 180 Nm.
Filling the water reservoir
Filling level display
1
Filling nozzle
2
1. Open the lock of the filling nozzle.
2. Attach the filling hose to the filling nozzle.
3. Fill the water reservoir.
4. Remove the filling hose and close the filling nozzle lock.
106
Filling the wiping water container
Wiping water container
1
Cover
2
Hydraulic fluid reservoir filling level display
3
Note
Adhere to the manufacturer information for the wiping water and
antifreeze.
1. Raise the attachment frame.
2. Unlock and remove the side panels.
3. Remove the lid from the wiping water container.
4. Fill with wiping water.
a Also add antifreeze in the case of potential frost.
5. Fit the lid on the wiping water container.
6. Attach the side panels again.
Checking the engine oil level
CAUTION

Danger of burns

Do not touch any hot surfaces such as engines, motors or gear-
boxes.
Screws
1
Cover
2
Oil dipstick
3
1. Park the vehicle on a level surface.
2. Unscrew the screws.
3. Remove the cover.
4. Pull out the oil dipstick.
5. Wipe the oil dipstick and insert it.
6. Pull out the oil dipstick.
7. Measure the oil level using the oil dipstick.
The oil level must lie between the "MIN" and "MAX" markings.
Top up with engine oil if the oil level is below the "MIN" mark-
ing.
English