Electrical Warnings - IKEA GENOMFRYSA Handbuch

ENGLISH
floor, adjusting them as required, and check
that the appliance is perfectly level using a
spirit level. Wait at least two hours before
switching the appliance on, to ensure that the
refrigerant circuit is fully efficient.
WARNING: When positioning the
appliance, ensure the supply cord is not
trapped or damaged.
WARNING: To avoid a hazard due to
instability, positioning or fixing of the
appliance must be done in accordance with
the manufacturer instructions. It's forbidden
to place the refrigerator in such way that the
metal hose of gas stove, metal gas or water
pipes, or electrical wires are in contact with
the refrigerator back wall (condenser coil).
To guarantee adequate ventilation, the
distance between the rear of the appliance
and the wall behind the appliance should
be 50 mm, to avoid access to hot surfaces.
A reduction of this space will increase the
Energy consumption of product. Please
remove the power cord from condenser hook
during installation before connecting product
to power supply.

ELECTRICAL WARNINGS

It must be possible to disconnect
the appliance from the power supply by
unplugging it if plug is accessible, or by a
multi-pole switch installed upstream of the
socket in accordance with the wiring rules and
the appliance must be earthed in conformity
with national electrical safety standards.
Do not use extension leads, multiple
sockets or adapters. The electrical
components must not be accessible to
the user after installation. Do not use the
appliance when you are wet or barefoot.
Do not operate this appliance if it has a
damaged power cable or plug, if it is not
working properly, or if it has been damaged
or dropped.
If the supply cord is damaged, it must
be replaced with an identical one by the
manufacturer, its service agent or similarly
qualified persons in order to avoid a hazard -
risk of electric shock.
WARNING: Do not locate multiple portable
socket-outlets or portable power supplies at
the rear of the appliance.
Feets of the product: in Fs not available; in
built in - the "feet are not adjustable - and the
METOD cabinet should be levelled with spririt
level.
7