Working With The Hedge Trimmer; Cutting Techniques; Cleaning And Maintenance - Parkside PHSA 20-Li A1 Originalbetriebsanleitung

GB IE
Working with the Hedge
Trimmer
During cutting work, ensure that no
contact is made with objects, e.g.
such as wire fencing or main plant
stems. This may result in damage to
the cutter bar.
• If the blades become jammed with solid
objects, turn the device off immediately
and remove the rechargeable battery.
Only then should you remove the object.
• Avoid overstraining the equipment dur-
ing work.

Cutting Techniques

• Cut thick branches beforehand using a
branch clippers.
• The double-sided cutter bar enables cut-
ting in both directions or, with a swing-
ing action, from one side to the other.
• In case of vertical cutting, move the
hedge trimmer uniformly forward or up
and down in an arc movement.
• In case of horizontal cutting, move
the hedge trimmer in a sickle-shaped
movement to the edge of the hedge, so
that cut branches fall to the ground.
• In order to achieve long straight lines,
the placing of tensioned guiding cords
is recommended.
Cutting Shaped Hedges:
growth and allows the hedge to thrive opti-
28
It is recommended
that hedges be cut
in a trapezoidal
shape, in order to
prevent stripping off
of the lower branch-
es. This corresponds
to the natural plant
mally. During cutting, only the new annual
growths are reduced and thus a dense
branching and a good screen will develop.
• Cut the sides of a hedge first. To do
this, move the hedge trimmer in the
direction of growth from bottom to top.
If you cut down from the top, the thin-
ner branches will move out, which may
result in some areas having sparse
growth or holes.
• Cut the top edge, according to taste, in a
flat shape, roof shape or rounded shape
• Trim young plants to the required
shape. The main growth should re-
main undamaged until the hedge has
reached the planned height. All other
shoots are lopped off to half size.
Care of Free-Growing Hedges:
Free-growing hedges are not shaped when
cut, although they must be regularly main-
tained so the hedge does not become too
high.
Cleaning and
Maintenance
Repair and servicing work not
described in this manual should
always be carried by our Service
Centre. Use only original parts.
Turn off the appliance and, before
doing any servicing, remove the
battery.
Wear gloves when handling the
safety knife bar. This will protect
you against cuts.
The following cleaning and servicing
should be done regularly. This will ensure
a long and reliable service life.