Operating The Chainsaw; Switching On; Checking The Chain Brake - Parkside PKS 2200 A1 Originalbetriebsanleitung

GB IE
• If you have no Grizzly bio-oil avail-
able, use chain lubrication oil with low
adhesive additive content.
• Empty the oil tank before longer peri-
ods (6-8 weeks) of non-use.
1. Unscrew the oil fill cap (2) and fill
C
up with chain oil.
2. Wipe off any spilled oil and
close the cap (2) again.
Always switch off the device
and allow the motor to cool
before filling with chain oil.
There is a risk of fire if oil
overflows.

Operating the chainsaw

Switch on the chainsaw only when
chain bar, saw chain and sprocket
chain wheel covering are correctly
assembled. Ensure the voltage of
the mains connection agrees with
the label on the device. Make sure
you have a secure stance. Make
sure before you start that the elec-
tric chain saw is not touching any-
thing.
Caution! Saw can oil up, see notes
on "Assembly - Mounting the saw
chain and blade"
D

Switching on

1. Check before the start, whether suffi-
cient chain oil is in the tank and, if nec-
essary, refill with chain oil (see Chapter
Operation Startup).
2. Form a loop from the end of the exten-
sion cable and hang this into the ten-
sion relief (17) on the rear grip (1).
44
3. Connect the device to the mains volt-
age.
4. Release the chain brake, where you
shift the brake arm (3) back against the
front grip (16).
5. Hold the electric chainsaw firmly with
both hands, with the right hand on the
rear grip (1) and the left hand on the
front handle (16). Thumb and finger
must close securely over the handles.
6. For switching on, activate the switch-on
block (14) with the right thumb and
then press the On/Off switch (13), the
electric power saw runs with highest
speed. Release the switch-on block (14)
again.
7. The power saw switches off when you
release the On/Off switch (13) again.
Switching for continuous running is not
possible.
Checking the chain
E
brake
The motor cannot be turned on if
the chain brake has engaged. Do
not employ the chain brake in order
to start the chainsaw or to switch it
off.
1. Place the electric chainsaw onto a
solid, flat surface. It must not contact
any objects.
2. Form a loop from the end of the exten-
sion cable and hang this into the ten-
sion relief (11) on the rear grip (1).
3. Connect the device to the mains volt-
age.
4. Release the chain brake by shifting the
brake arm (3) over against the front
grip (16).
5. Hold the electric chainsaw firmly with
both hands, with the right hand on the