How To Use - Panasonic MJ-L501 Bedienungsanleitung

How to use

① Install parts on the motor housing and attach the lid. (See P. GB12 - 14)
② Prepare ingredients. (See P. GB15 - 16)
③ Place containers under the juice spout and pulp spout.
When using the frozen cone, placing the pulp container is not necessary.
●
④ Insert the mains plug into a household mains socket.
1
Press the "I" (ON)
button.
2
Feed ingredients into the
feeding tube slowly and push
them down by using the food
pusher.
Feed ingredients little by little
●
approximately every 5 seconds.
When using more than one kind of
●
ingredient, feed them little by little
alternately.
Do not force to push ingredients into
●
the feeding tube.
In the case of jamming of ingredients
●
or idle running, press and hold the
"R" (REVERSE) button for several
seconds (See P. GB11).
3
After extracting is completed, press the
"O" (OFF) button and close the spout cap.
Continue to run until juice pomace or frozen
●
cream is completely extracted. It may cause
difficulty for opening the lid.
Pull out the mains plug.
●
Use the tip of cleaning brush to remove the pulp from juice spout and pulp spout.
●
Remove parts and clean them. (See P. GB19 - 20)
●
Do not move the juicer by holding the lid or juicing bowl. (Dropping parts may cause injury.)
Note
Depending on ingredients (especially hard ingredients), their pulp may mix into the juice.
●
If pulp is disturbing your drink, strain your drink.
When pulp is not coming out or pulp is accumulating back of the pulp spout and top of the juice
●
attachment, turn the switch off and remove them.
Preparations
Extracting
ON
I
O
•
R
Pulp spout
Pulp
container
After use
Food pusher
Feeding tube
Open the
spout cap
Juice spout
Juice
container
GB17