Before Use
Prohibited ingredients
●
●
●
(Frozen when raw or after being boiled)
●
●
Ingredient preparation
1
2
3
4
●
●
●
●
GB16
Tips
How to use
Extracting
Preparations
1 Install parts on the motor housing and assemble the lid. (P. GB12-14)
2 Prepare ingredients. (P. GB15-16)
3 Place containers under the juice spout and pulp spout.
●
When using the frozen attachment, placing the pulp container is
not necessary.
4 Insert the mains plug into a house hold mains socket.
1
2
feeding tube slowly and
push them down by using
the food pusher.
●
Feed ingredients little by little
approximately every 5 seconds.
●
When using more than one kind of
ingredients, feed them little by little
alternately.
●
Do not force to push ingredients into
the feeding tube.
●
In the case of jamming of ingredients
(REVERSE) button for several seconds
(P. GB11).
3
After extracting is completed,
and close the spout cap.
After use
●
Pull out the mains plug.
●
Use the tip of cleaning brush to remove the pulp from juice spout and pulp spout.
●
Remove parts and clean them. (P. GB18-19)
Do not move the juicer by holding the lid or juicing bowl. (Dropping parts may cause injury.)
Note
●
Depending on ingredients (especially hard ingredients), their pulp may mix into the juice.
If pulp is disturbing your drink, strain your drink.
●
When pulp is not coming out or pulp is accumulating back of the pulp spout and top of the juice attach-
ment, turn the switch off and remove them.
Food pusher
Feeding tube
Open the
spout cap
Pulp spout
Juice spout
Pulp container
Juice container
GB17