Stopping The Generator; Scope Of Applicability - Hitachi E10U Handbuch

STOPPING THE GENERATOR

1. Turn the electric appliance off.
2. Disconnect the plug of the electric appliance from the outlet.
3. Place the engine switch in the
NOTE: The fuel cock is closed when the engine switch is placed in the
STOP position.

SCOPE OF APPLICABILITY

Use the AC or DC power in the following operating range for electric appliances.Check the power consumption
(wattage) of the electric appliance to be connected.
CAUTION: ●Do not operate the generator at an overload where the total load of electric appliances
NOTE: If the operating range is exceeded or there is a fault in the electric appliance, the AC protector
turns off the circuit.
Downloaded from www.Manualslib.com
(STOP) position.
Operating range
Connected
Setting of output selection switch
electric appliance
950VA
Lighting, heater,
TV set, ratio, etc.
Up to 950W
Motor-driven tools
Up to 760W
General motors
Up to 430W
Battery
Up to 12V-8.3A
exceeds the operating range. Otherwise the generator will be broken.
●Part of motor-driven tools or generator motors may not operate even within the operating
range if the starting current is large or due to some conditions of the electric appliance.
manuals search engine
Remarks
600VA
Up to 600W
• If the DC power is used
simultaneously, select
950VA at the output
selection switch.
Up to 480W
Subtract 100W from the
operating range of the AC
electric appliance shown to
the left.
Up to 270W
———
English
Plug
AC outlet
Fig. 34
Engine switch
(STOP)
Fig. 35
17