Specifications - Makita HK0500 Bedienungsanleitung

ENGLISH (Original instructions)
1-1. Switch trigger
2-1. Adjusting dial
3-1. Bit

SPECIFICATIONS

• Due to our continuing programme of research and development, the specifications herein are subject to change without notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
Intended use
The tool is intended for chiselling work in concrete, brick
and stone as well as for driving and compacting with
appropriate accessories.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and can
only be operated on single-phase AC supply. They are
double-insulated in accordance with European Standard
and can, therefore, also be used from sockets without
earth wire.
Noise
The typical A-weighted noise level determined according
to EN60745:
Sound pressure level (L
Sound power level (L
Uncertainty (K) : 3 dB(A)
Vibration
The vibration total value (tri-axial vector sum) determined
according to EN60745:
Work mode : chiseling
Vibration emission (a
Uncertainty (K) : 1.5 m/s
The declared vibration emission value has been
•
measured in accordance with the standard test
method and may be used for comparing one tool
with another.
The declared vibration emission value may also be
•
used in a preliminary assessment of exposure.
Downloaded from www.Manualslib.com
Explanation of general view
3-2. Chuck cover
4-1. Bit
4-2. Chuck cover
Model
-1
Blows per minute (min )
Overall length
Net weight
Safety class
) : 83 dB(A)
pA
) : 94 dB(A)
WA
Wear ear protection
2
) : 9.5 m/s
h,CHeq
2
manuals search engine
ENE047-1
WARNING:
The vibration emission during actual use of the
•
power tool can differ from the declared emission
value depending on the ways in which the tool is
used.
ENF002-1
Be sure to identify safety measures to protect the
•
operator that are based on an estimation of
exposure in the actual conditions of use (taking
account of all parts of the operating cycle such as
the times when the tool is switched off and when it
is running idle in addition to the trigger time).
ENG905-1
For European countries only
EC Declaration of Conformity
We Makita
manufacturer declare that the following Makita
machine(s):
Designation of Machine:
Power Scraper
Model No./ Type: HK0500
are of series production and
ENG900-1
Conforms to the following European Directives:
2006/42/EC
And are manufactured in accordance with the following
standards or standardised documents:
EN60745
The technical documentation is kept by our authorised
representative in Europe who is:
Makita International Europe Ltd.
ENG901-1
Michigan Drive, Tongwell,
Milton Keynes, MK15 8JD, England
3
5-1. Change ring
6-1. Scaling chisel
6-2. Tile
HK0500
2,000 - 3,500
468 mm
3.2 kg
II
Corporation as the responsible
ENH101-14